Beveled reversible knives are standard. Correct alignment is ensured without the risk of distortion.6.Long-term reliability: large-diameter gearwheels in high-tensile forged steel with reinforced teeth.7.Perfect sealing: top-quality o-rings used on cutterbar bearing housings for a perfect, leak-free seal.Standard discs allow for clean cutting and quick crop evacuation. For added safety, heat-treated steel cups are welded to the disc.5.Minimum wear or distortion risks: idler gear fasteners are located in heat treated steel cups. This optimum position improves the load balance.3.Protection should an obstacle be struck: the Protectadrive® system is designed to protect the cutterbar gear train and minimizes the risk of downtime.4.High-wear resistance: knife attachment hardware is fully protected. The website is used and to improve our offerings) and to the use of tracking cookies (both from and from trusted partners of ours).1.Withstands the highest loads: special high-capacity bearings fitted in a one-piece sealed housing are not subject to distortion.2.Increased service life: disc pinion shaft bearings endure radial forces for maximum bearing life. Malliston koneissa on jousikevennys ja ripustus niittopalkin.
In the event of an impact between a disc and an obstacle, the shaft holding the disc can shear just above the bearing. Ultimate protection, from the externally removable Protectadrive disc bearing stations, provides maximum reliability and quick service. Advantages of the swath wheel include it fitting entirely under the curtain, not being in contact with the ground and eliminating damage when backing or turning sharply.Every minute saved during the hay season is precious. As crop leaves the cutting area, no outside support greatly reduces the chance of crop wrapping.The swath wheel is mounted behind the outer cone and functions to separate cut crop from uncut crop allowing the right tractor wheels to drive over the ground instead of previously cut crop. A recut of the grass is therefore avoided.
The hitch is not designed to be Quick-Hitch compatible. The frame allows up to a 2” offset to the right for tire clearance. It is important to note that all Select Series machines require the operator to lift the hitch and activate the cutterbar lift hydraulic circuit for headland maneuvers. GMD 24 and GMD 28 mowers have a longer top link attachment point due to the increased working widths.
0 kommentar(er)
